CLI Guide

Version Description
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.1 Introduced on the E-Series.
max-metric router-lsa
Configure the maximum cost of 65535 on a new router so that it functions as a stub router in the
network and OSPF traffic destined to other networks is not forwarded on a path through the router.
C-Series, E-Series, Z-Series, S4810
Syntax max-metric router-lsa [on-startup {announce-time | wait-for-bgp [wait-
time]}]
To remove the maximum metric assignment from an OSPF router and send LSAs
with the currently configured cost, enter no max-metric router-lsa [on-startup
{announce-time | wait-for-bgp [wait-time]}].
Parameters
on-startup
announce-time
Enter the time (in seconds) following boot-up during which
the maximum cost (65535) for transmitting OSPF traffic on
router interfaces is announced in LSAs and the router
functions as a stub router.
Range: 5 to 86400 seconds.
on-startup wait-
for-bgp [wait-
time]
Enable the router to announce the maximum metric in
OSPF LSAs until the BGP routing table converges with
updated routes. Default: 600 seconds.
You can also specify the time (in seconds) that the router
waits for the BGP routing table to converge before it stops
advertising the maximum cost in LSAs and advertises the
router’s currently configured OSPF cost. Range: 5 to 86400
seconds.
Defaults Not Configured.
Command Modes
ROUTER OSPF
Command History
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.1.(0.0) Introduced on the S4810 and Z9000.
8.4.2.5 Introduced on C-Series and E-Series TeraScale.
8.4.1.3 Introduced on E-Series ExaScale.
1204
Open Shortest Path First (OSPFv2 and OSPFv3)