CLI Guide

Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.1 Introduced on the E-Series.
Usage Information The following describes the show ip ospf process-id interface command
shown in the following example.
Item Description
GigabitEthernet... This line identifies the interface type slot/port and the status
of the OSPF protocol on that interface.
Internet Address... This line displays the IP address, network mask and area
assigned to this interface.
Process ID... This line displays the OSPF Process ID, Router ID, Network
type and cost metric for this interface.
Transmit Delay... This line displays the interface’s settings for Transmit Delay,
State, and Priority. In the State setting, BDR is Backup
Designated Router.
Designated
Router...
This line displays the ID of the Designated Router and its
interface address.
Backup
Designated...
This line displays the ID of the Backup Designated Router
and its interface address.
Open Shortest Path First (OSPFv2 and OSPFv3)
1167