CLI Guide

• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the
outgoing packets.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4820T.
8.5.1.0 Added support for 4-port 40G line cards.
8.2.1.0 Increased number of VLANs to 4094 (was 2094).
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command
ip tftp vrf
Configures an TFTP client with a VRF that is used to connect to the TFTP server.
Syntax
ip tftp [vrf vrf-name]
To undo the TFTP client configuration, use the no ip tftp [vrf vrf-name]
command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to
specify the VRF that is used by the TFTP client.
Defaults Disabled
Command Modes CONFIGURATION
116
Control and Monitoring