CLI Guide

track resolution ipv6 route
Configure the protocol-specific resolution value used to scale an IPv6 route metric.
Syntax
track resolution ipv6 route {isis resolution-value | ospf
resolution-value}
To return to the default setting, use the no track object-id command.
Parameters
object-id Enter the ID number of the tracked object. Use the range to
1 to 500.
isis resolution-
value
Enter the resolution used to convert the metric in the
routing table for ISIS routes to a scaled metric.
ospf resolution-
value
Enter the resolution used to convert the metric in the
routing table for OSPF routes to a scaled metric.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Usage Information
Use this command to configure the protocol-specific resolution value that
converts the actual metric of an IPv6 route in the routing table to a scaled metric in
the range 0 to 255.
The UP/DOWN state of a tracked IPv6 route is determined by the user-
configurable threshold (the threshold metric command) for a route’s metric in
the routing table. To provide a common tracking interface for different clients,
route metrics are scaled in the range 0 to 255, where 0 is connected and 255 is
inaccessible.
The protocol-specific resolution value calculates the scaled metric by dividing a
route's cost by the resolution value set for the route protocol:
• For ISIS, you can set the resolution in the range 1 to 1000, where the default is
10.
1092
Object Tracking