CLI Guide

The tracking process uses a protocol-specific resolution value to convert the
actual metric in the routing table to a scaled metric in the range 0 to 255. You can
configure the resolution value used to scale route metrics for supported protocols
with the track resolution ip route and track resolution ipv6 route
commands.
Related
Commands
• track ip route metric threshold – configure object tracking on the threshold of
an IPv4 route metric.
• track resolution ip route – configure the protocol-specific resolution value
used to scale an IPv4 route metric.
track interface ip routing
Configure object tracking on the routing status of an IPv4 Layer 3 interface.
Syntax
track object-id interface interface ip routing
To return to the default setting, use the no track object-id command.
Parameters
object-id Enter the ID number of the tracked object. The range is 1 to
500.
interface Enter one of the following values:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE then the slot/port/subport
information.
• For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE then the slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel
then a number.
• For a tunnel interface, enter the keyword tunnel.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults None
Command Modes CONFIGURATION
Object Tracking
1079