CLI Guide

Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000,
Introduced on the S6000–ON, and Z9000 switches.
Example
Related
Commands
• ipv6 nd ra-guard enable — configure the RA guard related commands.
• ipv6 nd ra-guard policy — define the RA guard policy name and enter the RA
guard policy list configuration mode.
• device-role — specify the role of the device attached to the port.
• hop-limit — enable the verification of the advertised hop count limit.
• mtu — set the maximum transmission unit (MTU) value.
• other-config-flag — enable the verification of the advertised other
configuration parameter.
• reachable-time — set the advertised reachability time.
• retrans-timer — set the advertised retransmission time.
• router-preference maximum — enable the verification of the advertised default
router preference (DRP) value.
• trusted-port — apply the policy to trusted ports.
• ipv6 nd raguard attach-policy — apply the IPv6 RA guard to a specific interface.
show ipv6 neighbors
Display IPv6 discovery information. Entering the command without options shows all IPv6 neighbor
addresses stored on the control processor (CP).
Syntax
show ipv6 neighbors [vrf vrf-name] [ipv6-address| interface interface]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and the name of the VRF to display
the neighbors corresponding to that VRF.
NOTE: If you do not specify this option, neighbors corresponding to
the default VRF are displayed.
ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::x format.
1068
Neighbor Discovery Protocol (NDP)