CLI Guide

Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–
ON, and Z9000 switches.
device-role
Specify the role of the device attached to the port.
Syntax
device-role {host | router}
To reset the device role, use the no device-role {host | router}
command.
Parameters
host Enter the keyword host to set the device-role as host.
router Enter the keyword router to set the device-role as router.
Defaults None
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–
ON, and Z9000 switches.
Related
Commands
• ipv6 nd raguard policy policy-name — define the RA guard policy name and
enter the RA guard policy configuration mode.
• ipv6 nd ra-guard enable — configure the RA guard related commands.
hop-limit
Enable the verification of the advertised hop count limit. If this command is not configured, the
verification process is bypassed.
Syntax
hop-limit {maximum | minimum limit}
Neighbor Discovery Protocol (NDP)
1055