CLI Guide

Parameters
in Enter the keyword in to enable incoming SA filtering.
out Enter the keyword out to enable outgoing SA filtering.
peer-address Enter the peer address of the MSDP peer in a dotted decimal
format (A.B.C.D.).
access-list name Enter the name of an extended ACL that contains permitted
SAs. If you do not use this option, all local entries are
blocked.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the E-Series.
ip msdp sa-limit
Configure the upper limit of source-active (SA) entries in SA-cache.
Syntax
ip msdp sa-limit number
To return to the default, use the no ip msdp sa-limit number command.
Parameters
number Enter the maximum number of SA entries in SA-cache. The
range is from 1 to 500000.
Multicast Source Discovery Protocol (MSDP)
1019