Reference Guide

IP SA IP DA srcAS and
srcPeerAS
dstAS and
dstPeerAS
Description
there is no AS
information.
static/
connected/IGP
BGP 0 Exported src_as and
src_peer_as are
zero because there
is no AS
information for
IGP.
BGP static/
connected/IGP
—
Exported
—
Exported
Prior to Dell
Networking OS
version 7.8.1.0,
extended gateway
data is not
exported because
IP DA is not learned
via BGP.
Version 7.8.1.0
allows extended
gateway
information in
cases where the
source and
destination IP
addresses are
learned by different
routing protocols,
and for cases
where is source is
reachable over
ECMP.
BGP BGP Exported Exported Extended gateway
data is packed.
Enabling and Disabling sFlow on an Interface
By default, sFlow is disabled on all interfaces.
This CLI is supported on physical ports and link aggregation group (LAG) ports.
To enable sFlow on a specific interface, use the following command.
• Enable sFlow on an interface.
INTERFACE mode
[no] sflow ingress-enable
To disable sFlow on an interface, use the no version of this command.
sFlow
809