Reference Guide

To create the Members VLANs for this FRRP group, use the following commands on all of the Transit
switches in the ring.
1. Create a VLAN with this ID number.
CONFIGURATION mode.
interface vlan vlan-id
VLAN ID: the range is from 1 to 4094.
2. Tag the specified interface or range of interfaces to this VLAN.
CONFIG-INT-VLAN mode.
tagged interface {range}
Interface:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/
subport
information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port/subport
information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the slot/port/
subport information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the slot/port/subport
information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the slot/port
information.
3. Assign the Primary and Secondary ports and the Control VLAN for the ports on the ring.
CONFIG-FRRP mode.
interface primary interface secondary interface control-vlan vlan id
Interface:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/
subport
information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port/subport
information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the slot/port/
subport information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the slot/port/subport
information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the slot/port
information.
VLAN ID: Identification number of the Control VLAN.
4. Configure a Transit node.
CONFIG-FRRP mode.
mode transit
5. Identify the Member VLANs for this FRRP group.
CONFIG-FRRP mode.
member-vlan vlan-id {range}
Force10 Resilient Ring Protocol (FRRP)
343