Reference Guide

• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the slot/port/
subport information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the slot/port/subport
information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the slot/port
information.
3. Assign the Primary and Secondary ports and the control VLAN for the ports on the ring.
CONFIG-FRRP mode.
interface primary interface slot/port[/subport] secondary int slot/port[/
subport] control-vlan vlan id
Interface:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/
subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port/subport
information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the slot/port/
subport information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the slot/port/subport
information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the slot/port
information.
4. Configure the Master node.
CONFIG-FRRP mode.
mode master
5. Identify the Member VLANs for this FRRP group.
CONFIG-FRRP mode.
member-vlan vlan-id {range}
VLAN-ID, Range: VLAN IDs for the ring’s member VLANS.
6. Enable FRRP.
CONFIG-FRRP mode.
no disable
Configuring and Adding the Member VLANs
Control and member VLANS are configured normally for Layer 2. Their status as Control or Member is
determined at the FRRP group commands.
For more information about configuring VLANS in Layer 2 mode, refer to the Layer 2 chapter.
Be sure to follow these guidelines:
• All VLANS must be in Layer 2 mode.
• Tag control VLAN ports. Member VLAN ports, except the Primary/Secondary interface, can be tagged
or untagged.
• The control VLAN must be the same for all nodes on the ring.
342
Force10 Resilient Ring Protocol (FRRP)