Users Guide

aggressive (OPTIONAL) Enter the keyword aggressive to change the link state to “error-
disabled” when a far-end failure the software detects on that interface. When an interface
is placed in “error-disabled” state, enter the fefd reset command to reset the
interface state.
Defaults Normal
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Legacy E-Series
command.
Related Commands
• fefd — enable far-end failure detection.
fefd reset
Reset all interfaces or a single interface that was in “error-disabled” mode.
Syntax
fefd reset [interface]
Parameters
interface (OPTIONAL) Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
slot/port/subport information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port/subport information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the slot/
port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
slot/port information.
Defaults Not congured.
Command Modes EXEC Privilege
Layer 2 859