Users Guide

• For a 100-Gigabit interface, enter the keyword hundredGigE then the slot/port
information.
in | out Identify whether ACL is applied on ingress or egress side.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.4.2.1 Introduced on the S-Series.
8.2.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series. Increased the name string to accept up to 140 characters.
Prior to version 7.8.1.0, names are up to 16 characters long.
7.4.1.0 Introduced on the E-Series TeraScale.
Usage Information
Field Description
“Ingress IPv6...” Displays the name of the IPv6 ACL, in this Example “AclList1”.
“seq 10...” Displays the lter. If the keywords count or byte were congured in the lter, the
number of packets or bytes processed by the lter is displayed at the end of the line.
Example
Dell#show ipv6 accounting access-list
!
Ingress IPv6 access list AclList1 on GigabitEthernet 9/0
Total cam count 15
seq 10 permit icmp host 3333:: any mobile-advertisement log
seq 15 deny tcp any any rst
seq 20 permit udp any any gt 101 count (0 packets)
!
Dell#
permit icmp
To allow all or specic internet control message protocol (ICMP) messages, congure a lter.
Syntax
To remove this lter, you have two choices:
• Use the no seq sequence-number command if you know the lter’s sequence number.
• Use the no permit icmp {source address mask | any | host ipv6-address}
{
destination address | any | host ipv6-address} command.
Parameters
742 IPv6 Access Control Lists (IPv6 ACLs)