Users Guide

Usage Information
Because this command calculates based on a Layer 2 hash algorithm, use this command to display ows for
switched Layer 2 packets, not for routed packets (use the show ip flow command to display routed packets).
The show port-channel-flow command returns the egress port identication in a given port-channel if a
valid ow is entered. A mismatched ow error occurs if MAC-based hashing is congured for a Layer 2 interface
and you are trying to display a Layer 3 ow.
The output displays three entries:
• Egress port for unfragmented packets.
• In the event of fragmented packets, the egress port of the rst fragment.
• In the event of fragmented packets, the egress port of the subsequent fragments.
NOTE: In the show port channel flow command output, the egress port for an unknown unicast,
multicast, or broadcast trac is not displayed.
The following example shows the show port-channel-flow outgoing-port-channel number
incoming-interface interface source-mac address destination-mac address
• Load-balance is congured for MAC
• Load-balance is congured for IP 4-tuple/2-tuple
• A non-IP payload is going out of Layer 2 LAG interface that is a member of VLAN with an IP address
Example
Dell# show port-channel-flow outgoing-port-channel 1 incoming-interface te
1/1/3
source-mac 00:00:50:00:00:00 destination-mac 00:00:a0:00:00:00
Egress Port for port-channel 1, for the given flow, is Te 1/2/2
Enhanced Validation of Interface Ranges
You can avoid specifying spaces between the range of interfaces, separated by commas, that you congure by using the interface
range
command. For example, if you enter a list of interface ranges, such as interface range hu 1/1,fo 1/2/1, this
conguration is considered valid. The comma-separated list is not required to be separated by spaces in between the ranges. You can
associate multicast MAC or hardware addresses to an interface range and VLANs by using the mac-address-table static
multicast-mac-address vlan vlan-id output-range interface command.
ip http source-interface
Specify an interface as the source interface for HTTP connections.
Syntax
ip http source-interface interface
To delete an interface, use theno ip http source-interface interface command.
Parameters
interface
Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
slot/port/subport information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port/subport information.
Interfaces 659