Users Guide

To delete a Port Channel, use the no interface port-channel channel-number command.
Parameters
channel-number For a Port Channel interface, enter the keywords port-channel then a number. The
range is from 1 to 4096.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Increased the number of port channels to 4096.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on S4810.
8.3.11.1 Introduced on Z9000.
8.1.1.0 Introduced on E-Series.
7.6.1.0 Introduced on S-Series.
7.5.1.0 Introduced on C-Series.
pre-Version 6.2.1.0 Introduced on E-Series.
Usage Information
Port Channel interfaces are logical interfaces and can be either in Layer 2 mode (by using the switchport
command) or Layer 3 mode (by conguring an IP address). You can add a Port Channel in Layer 2 mode to a
VLAN.
The shutdown, description, and name commands are the only commands that you can congure on an
interface while it is a member of a Port Channel. To add a physical interface to a Port Channel, the interface can
only have the
shutdown, description, and name commands congured. The Port Channel’s conguration is
applied to the interfaces within the Port Channel.
A Port Channel can contain any physical interface. Based on the rst interface congured in the Port Channel and
enabled, Dell Networking OS determines the common speed. For more information, refer to channel-member.
If the line card is in a Jumbo mode chassis, you can also congure the mtu and ip mtu commands. The Link MTU
and IP MTU values congured on the channel members must be greater than the Link MTU and IP MTU values
congured on the Port Channel interface.
If the stack—unit card is in a Jumbo mode chassis, you can also congure the mtu and ip mtu commands. The
Link MTU and IP MTU values congured on the channel members must be greater than the Link MTU and IP MTU
values congured on the Port Channel interface.
652 Interfaces