Users Guide

Version Description
9.8(1.0) Introduced on the Z9100-ON.
Example
Dell#show system stack-unit 1 fanout configured
Configured fan out ports in stack-unit 1
Port Mode Speed
1 Dual 50G
2 Quad 10G
3 Quad 10G
4 Single 40G
5 Quad 25G
8 Single 40G
10 Single 40G
11 Single 40G
12 Single 40G
13 Quad 25G
16 Single 40G
17 Single 40G
18 Dual 50G
19 Quad 10G
20 Quad 10G
27 Single 40G
28 Dual 50G
29 Single 40G
32 Dual 50G
show interfaces switchport
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode interfaces’ IEEE 802.1Q tag status
and VLAN membership.
Syntax
show interfaces switchport [interface-type | stack-unit unit-id ]
Parameters
interface-type (OPTIONAL) Enter one of the following keywords and the interface information:
For a port channel interface, enter the keywords port-channel then a number.
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port
/subport information.
For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
slot/port/subport information.
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port/subport information.
For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the slot/
port/subport information.
For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
slot/port information.
For a backup interface for this interface, enter the keyword backup.
NOTE: This command also enables you to view information corresponding to a
range of ports.
For physical interfaces, you can specify multiple ports as slot/port-range. For
example, if you want to display information corresponding to all ports between 1 and 4,
specify the port range as show interfaces interface-type 1/1 - 4.
For port–channel interfaces, you can specify multiple ports as port-range. For
example, if you want to display information corresponding to all ports between 1 and 4,
specify the port range as
show interfaces port—channel 1 - 4.
634
Interfaces