Users Guide

off off off off
off off off off
off off off off
off off off off
off off off off
off off off off
off on on off
off off off off
off off off off
on off off on
on on on on
on on on on
off off off off
off off off off
on on on on
on on on on
Related Commands
• show running-cong — display the ow conguration parameters (non-default values only).
• show interfaces — display the negotiated ow control parameters.
interface
Congure a physical or virtual interface on the switch.
Syntax
interface interface
Parameters
interface Enter one of the following keywords and the interface information:
• For a null interface, enter the keyword null then the slot/port information. The Null
interface number is 0.
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port/subport information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the slot/
port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
slot/port information.
• For a Tunnel interface, enter the keyword tunnel then the tunnel ID. The range is
from 1 to 16383.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a port channel interface, enter the keywords port-channel then a number.
Defaults
Not congured.
Command Modes CONFIGURATION
598 Interfaces