Users Guide

range
• For non-ON platforms, you can specify multiple ports as slot/port-range. For
example, if you want to display information corresponding to all ports between 1 and 4,
specify the port range as show interfaces interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/port/[subport] -
slot/port/[subport]. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as show
interfaces interface-type 1/1/1 - 1/1/4.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.9(0.0) Introduced on the S4810, S4820T, S3048-ON, S4048-ON, S5000, S6000, S6000–ON,
and Z9500.
Usage Information
Use the default interface command to set a Gigabit Ethernet, 10- Gigabit Ethernet, or 40-Gigabit Ethernet
interface to its factory-default state. By default, a physical interface is disabled (shutdown) with no assigned IP
address or switchport (no ip address). This command removes all software settings and all L3, VLAN, VXLAN, and
port-channel congurations on a physical interface.
Example
Dell(conf-if-te-1/5/1)# show config
!
interface TenGigabitEthernet 1/5/1
description testconfig
no ip address
portmode hybrid
switchport
rate-interval 8
mac learning-limit 10 no-station-move
no shutdown
Dell(conf-if-te-1/5/1)#
Dell(conf)# default interface tengigabitethernet 1/5/1
Dell(conf-if-te-1/5/1)# show config
!
interface TenGigabitEthernet 1/5/1
no ip address
shutdown
Related Commands
• show running-cong – display the current conguration.
duplex (10/100 Interfaces)
Congure duplex mode on the Management Interface interfaces where the speed is set to 10/100.
Syntax
duplex {half | full}
To return to the default setting, use the no duplex command.
Parameters
half Enter the keyword half to set the physical interface to transmit only in one direction.
Interfaces 593