Users Guide

Te 1/13/2 P7 0 0 0
Dell(conf)#
ETS Commands
The following ETS commands are supported on the Dell Networking OS.
dcb-enable
Enable data center bridging.
Syntax
dcb enable[pfc-queues 1|4]
To disable DCB, use the no dcb enable command.
Parameters
pfc-queues Enter the pfc-queue range. To disable DCB, use the no dcb enable command. The range is
from 1 or 4.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
For ETS functioning, rst assign the etsacl space using the cam-acl command.
Dell(conf)#cam-acl l2acl 2 ipv4acl 0 ipv6acl 0 ipv4qos 2 l2qos 0 l2pt 0
ipmacacl 0 vman-qos 0 fcoeacl 2 etsacl 1 iscsi 2
Related Commands
• dcb <ets | pfc> enable — enable priority ow control or enhanced transmission selection on interface.
clear ets counters
Clear all ETS TLV counters on an interface.
Syntax
clear ets counters port-type slot/port[/subport]
Parameters
port-type Enter the keywords port-type then the slot/port information. Enter the subport
number if a 40G port is fanned-out into 10G ports.
Data Center Bridging (DCB) 431