Users Guide

[vman-qos | vman-
dual-qos number]
ipv4pbr
numberopenow
{4|8} | fcoe number
[vrfv4acl number]
The fcoe range is 0–8 groups. Each group has 256 entries; the value given must be an
even number. This information is stored in the NVRAM and is eective after rebooting the
switch.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added the nlbcluster ACL keyword. Introduced on the S6000-ON.
9.4.(0.0) Added support for PBR and VRF.
9.2(1.0) Introduced on the Z9500.
9.2(0.2) Added support for fcoe.
9.1.(0.0) Added support for OpenFlow.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.2 Claried block information for the S4810.
8.3.10.0 Introduced on the S4810.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information
Save the new CAM settings to the startup-cong (write-mem or copy run start) then reload the system
for the new settings to take eect.
The total amount of space allowed is 13 FP Blocks. System ow requires three blocks; these blocks cannot be
reallocated. Only 9 number of blocks can be congured by the user .
If allocation values are not entered for the CAM regions, the value is 0.
If you enable BMP, to perform a reload on the chassis to upgrade any conguration changes that have changed
the NVRAM content, use the command reload conditional nvram-cfg-change.
408 Content Addressable Memory (CAM)