Users Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced on the E-Series.
Usage Information The remark command is available in each ACL mode. You can congure up to 4294967291 remarks for a given IP
ACL and 65536 remarks for a given MAC ACL.
The following example shows the use of the remark command twice within CONFIGURATION-STANDARD-
ACCESS-LIST mode. The same sequence number was used for the remark and for an associated ACL rule. The
remark precedes the rule in the running-cong because it is assumed that the remark is for the rule with the same
sequence number, or the group of rules that follow the remark.
Example
Dell(config-std-nacl)# remark 10 Deny rest of the traffic
Dell(config-std-nacl)# remark 5 Permit traffic from XYZ Inc.
Dell(config-std-nacl)# show config
!
ip access-list standard test
remark 5 Permit traffic from XYZ Inc.
seq 5 permit 1.1.1.0/24
remark 10 Deny rest of the traffic
seq 10 deny any
Dell(config-std-nacl)#
Related Commands
• show cong — display the current ACL conguration.
show cong
Display the current ACL conguration.
Syntax
show config
Command Modes
• CONFIGURATION-STANDARD-ACCESS-LIST
• CONFIGURATION-EXTENDED-ACCESS-LIST
• CONFIGURATION-MAC ACCESS LIST-STANDARD
• CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
Access Control Lists (ACL) 171