Users Guide

• seq (for IP ACLs)
• seq (for IPv6 ACLs)
• permit udp (for IPv6 ACLs)
• permit tcp (for IPv6 ACLs)
• permit icmp (for IPv6 ACLs)
• permit (for IPv6 ACLs)
• deny udp (for IPv6 ACLs)
• deny tcp (for IPv6 ACLs)
• deny icmp (for Extended IPv6 ACLs)
• deny (for IPv6 ACLs)
Commands Common to all ACL Types
The following commands are available within each ACL mode and do not have mode-specic options. Some commands in this chapter may
use similar names, but require dierent options to support the dierent ACL types (for example, the deny and permit commands).
remark
Enter a description for an ACL entry.
Syntax
remark [remark-number] [description]
Parameters
remark-number Enter the remark number. The range is from 0 to 65535 for MAC ACL and 0 to
4294967290 for IP ACL.
NOTE: You can use the same sequence number for the remark and an ACL
rule.
description Enter a description of up to 80 characters.
Defaults Not congured.
Command Modes
• CONFIGURATION-STANDARD-ACCESS-LIST
• CONFIGURATION-EXTENDED-ACCESS-LIST
• CONFIGURATION-MAC ACCESS LIST-STANDARD
• CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
170 Access Control Lists (ACL)