Users Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related
Commands
● show ip interface — display the interface routing status and configuration.
ip route
Assign a static route to the switch.
Syntax
ip route [vrf vrf-name] ip-address mask {ip-address | interface [ip-
address]} [distance] [permanent] [tag tag-value] [vrf vrf-name] [weight
weight-value]
To delete a specific static route, use the no ip route destination mask command.
To delete all routes matching a certain route, use the no ip route destination mask command.
Parameters
vrf vrf-name (Optoinal) Enter the keyword vrf and then the name of the VRF to configure a
static route corresponding to that VRF. Use this VRF option after the ip route
keyword to configure a static route on that particular VRF.
destination Enter the IP address in dotted decimal format of the destination device.
mask Enter the mask in the slash prefix format (/x) of the destination IP address.
ip-address Enter the IP address of the forwarding router in dotted decimal format.
interface Enter one of the following keyword followed by the interface information
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the stack/slot/port/subport information.
● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE
then the stack/slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
stack/slot/port[/subport] information.
● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the
stack/slot/port/subport information.
● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the stack/slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a Null interface, enter the keyword null then the Null interface number.
640 IPv4 Routing