Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S6100-ON

1361

● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the

stack/slot/port/subport information.

● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then

the stack/slot/port information.

Defaults Not configured.

Command Modes CONF-IF-VLAN

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.11.1 Introduced on the Z9000.

8.2.1.0 Introduced on the E-Series.

7.6.1.0 Introduced on the C-Series and S-Series.

Usage

Information

Enable the stackable VLAN (using the vlan-stack compatible command) on the VLAN prior to

adding a member to the VLAN.

Commands

● vlan-stack compatible — enables stackable VLAN on a VLAN.

stack-unit stack-group

Configure a stacking group specified by an ID.

Syntax

[no] stack-unit unit-id stack-group stack-group-id

To remove the current stack group configuration, use the no stack-unit unit-id stack-group

stack-id command.

Parameters

unit-id

Enter the stack unit ID.

stack-group-id

Enter the stack group ID. The range is from 0 to 16.

Command Modes CONFIGURATION