Users Guide

Reload-Type : normal-reload [Next boot : normal-reload]
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
-----------------------------------------------------------------------------------
-
0 Member not present S6000-ON
1 Member not present
2 Standby online S6000-ON S6000-ON 1-0(0-3387) 128
3 Member not present S6000-ON
4 Member not present
5 Management online S6000-ON S6000-ON 1-0(0-3387) 128
-- Power Supplies --
Unit Bay Status Type FanStatus FanSpeed(rpm)
---------------------------------------------------------------------------
2 0 up AC up 6720
2 1 up AC up 6656
5 0 up AC up 6688
5 1 down UNKNOWN down 0
-- Fan Status --
Unit Bay TrayStatus Fan0 Speed Fan1 Speed
-----------------------------------------------------------------------------------
-
2 0 up up 7021 up 7072
2 1 up up 7072 up 7021
2 2 up up 7021 up 7021
5 0 up up 7072 up 7021
5 1 up up 7021 up 6971
5 2 up up 7072 up 7021
Speed in RPM
Dell#
Virtual IP
You can manage the stack using a single IP, known as a virtual IP, that is retained in the stack even after a
failover.
The virtual IP address is used to log in to the current master unit of the stack. Both IPv4 and IPv6 addresses
are supported as virtual IPs.
Use the following command to configure a virtual IP: Dell(conf)#virtual-ip {ip-address | ipv6–
address | dhcp}
Failover Roles
If the stack master fails (for example, is powered off), it is removed from the stack topology.
The standby unit detects the loss of peering communication and takes ownership of the stack management,
switching from the standby role to the master role. The distributed forwarding tables are retained during the
failover, as is the stack MAC address. The lack of a standby unit triggers an election within the remaining units
for a standby role.
Stacking 943