Users Guide

privilege exec level 4 resequence
privilege configure level 3 line
privilege configure level 3 interface tengigabitethernet
Dell#telnet 10.11.80.201
Dell#?
configure Configuring from terminal
disable Turn off privileged commands
enable Turn on privileged commands
ethernet Ethernet commands
exit Exit from the EXEC
ip Global IP subcommands
ipv6 Global IPv6 subcommands
monitor Monitoring feature
ping Send echo messages
quit Exit from the EXEC
show Show running system information
Dell#config
Dell(conf)#do show priv
Current privilege level is 3.
Dell(conf)#?
end Exit from configuration mode
exit Exit from configuration mode
interface Select an interface to configure
line Configure a terminal line
Dell(conf)#
Dell(conf)#interface ?
tengigabitethernet TenGigabit Ethernet interface
Dell(conf)#
Dell(conf)#interface tengigabitethernet 1/26/1
Dell(conf-if-te-1/26/1)#?
end Exit from configuration mode
exit Exit from interface configuration mode
Dell(conf-if-te-1/26/1)#exit
Dell(conf)#
Dell(conf)#line ?
console Primary terminal line
vty Virtual terminal
Dell(conf)#line vty 0
Dell(config-line-vty)#exit
Dell(conf)#
Applying a Privilege Level to a Username
To set the user privilege level, use the following command.
• Configure a privilege level for a user.
CONFIGURATION mode
username username privilege level
Applying a Privilege Level to a Terminal Line
To set a privilege level for a terminal line, use the following command.
• Configure a privilege level for a user.
CONFIGURATION mode
Management 65