Users Guide
NOTE: After you configure a static IPv6 route (the ipv6 route command) and configure the forwarding
router’s address (specified in the ipv6 route command) on a neighbor’s interface, the IPv6 neighbor
does not display in the
show ipv6 route command output.
• Set up IPv6 static routes.
CONFIGURATION mode
ipv6 route [vrf vrf-name] prefix interface-type slot/port [/subport] forwarding
router tag
• vrf vrf-name:(OPTIONAL) name of the VRF.
• prefix: IPv6 route prefix
• slot/port [/subport]: interface type and slot/port[/subport]
• forwarding router: forwarding router’s address
• tag: route tag
Enter the keyword interface then the type of interface and slot/port information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/
subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-channel then a number.
• For a Null interface, enter the keyword null then the Null interface number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Configuring Telnet with IPv6
The Telnet client and server in Dell Networking OS supports IPv6 connections. You can establish a Telnet
session directly to the router using an IPv6 Telnet client, or you can initiate an IPv6 Telnet connection from
the router.
NOTE
: Telnet to link local addresses is supported on the system.
• Enter the IPv6 Address for the device.
EXEC mode or EXEC Privileged mode
telnet [vrf vrf-name] ipv6 address
• ipv6 address: x:x:x:x::x
• mask: prefix length is from 0 to 128.
NOTE: IPv6 addresses are normally written as eight groups of four hexadecimal digits, where each
group is separated by a colon (:). Omitting zeros is accepted as described in Addressing.
SNMP over IPv6
You can configure SNMP over IPv6 transport so that an IPv6 host can perform SNMP queries and receive
SNMP notifications from a device running Dell Networking OS IPv6. The Dell Networking OS SNMP-server
IPv6 Routing 492