Users Guide

Stack MAC : 34:17:eb:f2:c2:c4
Reload-Type : normal-reload [Next boot : normal-reload]
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
------------------------------------------------------------------------
1 Management online S6000-ON S6000-ON 1-0(0-3932) 128
2 Member not present
3 Member not present
4 Member not present
5 Member not present
6 Member not present
-- Power Supplies --
Unit Bay Status Type FanStatus FanSpeed(rpm)
------------------------------------------------------------
1 1 up AC absent 0
1 2 absent absent 0
-- Fan Status --
Unit Bay TrayStatus Fan0 Speed Fan1 Speed
-----------------------------------------------------------------
1 1 up up 0 up 0
1 2 up up 0 up 0
1 3 up up 0 up 0
Speed in RPM
Undoing Commands
When you enter a command, the command line is added to the running configuration file (running-config).
To disable a command and remove it from the running-config, enter the no command, then the original
command. For example, to delete an IP address configured on an interface, use the
no ip address ip-
address command.
NOTE: Use the help or ? command as described in Obtaining Help.
Example of Viewing Disabled Commands
Dell(conf)#interface tengigabitethernet 1/17/1
Dell(conf-if-te-1/17/1)#ip address 192.168.10.1/24
Dell(conf-if-te-1/17/1)#show config
!
interface tenGigabitEthernet 1/17/1
ip address 192.168.10.1/24
no shutdown
Dell(conf-if-te-1/17/1)#no ip address
Dell(conf-if-te-1/17/1)#show config
!
interface TenGigabitEthernet 1/17/1
no ip address
no shutdown
Layer 2 protocols are disabled by default. To enable Layer 2 protocols, use the no disable command. For
example, in PROTOCOL SPANNING TREE mode, enter
no disable to enable Spanning Tree.
Configuration Fundamentals 43