Setup Guide

CAUTION: Always wear an electrostatic discharge (ESD)-preventive wrist or
heel ground strap when handling a system and its components. As with all
electrical devices of this type, take all necessary safety precautions to prevent
injury when installing this system. ESD damage can occur if components are
mishandled.
CAUTION: Only trained and qualified personnel should install this equipment.
Read this guide before installing and powering up the system.
WARNING: This is a condensed reference. Read the safety instructions in your
Safety, Environmental, and Regulatory information booklet before you begin.
Installing the Ground Lug and Bracket
Assembly
Install the ground (GND) lug and bracket assembly, with a ground wire attached,
before you install the S6010-ON switch in a rack.
Dell Networking supplies a kit with the following:
• One two-hole UL-certified GND lug
• L-bracket
• Two flat head screws (to attach lug to bracket)
• Two pan head screws (to attach assembly to chassis)
You must supply:
• A wire that complies with your local electrical codes in size and color (typically
the wire is 14 AWG, colored green or green with a yellow stripe).
• An anti-oxidant compound (Dell Networking recommends NOALOX 4 or
equivalent).
• A crimping tool.
• A thread-locker compound (Dell Networking recommends Threadlocker Blue
242 or equivalent).
1 Attach the end of the ground wire to the GND lug:
a Coat the bare end of the wire with an anti-oxidant compound.
b Insert the end of the wire into the lug.
Install the Hardware 6