Setup Guide

Install the Hardware

This information describes installation of the S6010-Open Networking (ON) system.

Dell Networking recommends completing the installation procedures in the order

presented here.

Topics:

• Operation and Safety Considerations

• Installing the Ground Lug and Bracket Assembly

• Installing the Dell ReadyRails System

• Install the System

• Completing the Ground Wire Installation

• Installing AC or DC Power Supplies

• Installing a Fan Module

• Installing the SFP+ and QSFP+ Optics

• Supply Power and Power Up the System

• After Installing the S6010–ON

Operation and Safety Considerations

Before installing the switch, review these operation and safety guidelines.

Review these guidelines for switch installation:

• You have enough clearance to the front of the switch so you can read the light

emitting diodes (LEDs).

• The AC power cord reaches from the power outlet to the power supply unit

(PSU) side connector.

• The switch is rack-mounted before you power it up.

• Cabling is away from sources of electrical noise, such as radios, power lines, and

fluorescent lighting. Ensure that the cabling is safely away from other devices

that might damage the cables. If needed, allow one rack unit (RU) space

between devices to provide room for cabling.

• Airflow around the switch and through the vents is unrestricted.

Install the Hardware 4