Setup Guide

enable [password | secret] [level level] [encryption-type]
password
Creating a Port-based VLAN
The default VLAN (VLAN 1) is part of the system startup configuration and does not
require configuration.
To configure a port-based VLAN, create the VLAN and then add physical interfaces
or port channel (LAG) interfaces to the VLAN.
• Configure a port-based VLAN (if the vlan-id is different from the Default VLAN
ID) and enter INTERFACE VLAN mode.
CONFIGURATION mode
interface vlan vlan-id
After you create a VLAN, assign interfaces in Layer 2 mode to the VLAN as
needed.
To view the configured VLANs, use the show vlan command in EXEC Privilege
mode.
Connect the System to the Network
After you have completed the hardware installation and software configuration for
the system, connect to your company network by following your company’s
cabling requirements.
Configure the Software 29