Setup Guide

Configuring a Host Name
The host name appears in the prompt. The default host name is Dell.
Host names must start with a letter, end with a letter or digit, and must have
characters, letters, digits, and hyphens in the string.
• Create a host name.
CONFIGURATION mode
hostname name
Remote Access to the System
You can configure the S6010–ON system for Telnet remote access.
The system has a dedicated management port and a management routing table that
is separate from the IP routing table.
Configure as described in the following topics:
1 Configuring the Management Port IP Address
2 Configuring the Management Route
3 Configuring the Username and Password
Configuring the Management Port IP Address
In order to access the system remotely, assign IP addresses to the management
ports.
1 Enter INTERFACE mode for the Management port.
CONFIGURATION mode
interface ManagementEthernet slot/port
2 Assign an IP address to the interface.
INTERFACE mode
ip address ip-address/mask
3 Enable the interface.
INTERFACE mode
Configure the Software 27