Install Guide

Micro USB-B console port access
The Micro USB-B console port is to the left of the RS-232/RJ-45 console port on the I/O side of the switch.
NOTE: The S6010-ON switch uses the Silicon Labs CP2109 USB-B chip. To nd the correct USB-B universal asynchronous
receiver-transmitter (UART) driver, see https://www.silabs.com/products/development-tools/software/usb-to-uart-bridge-vcp-
drivers.
The terminal settings are the same for the Micro USB-B console port and the RS-232/RJ-45 console port:
115200-baud rate
No parity
Eight data bits
One stop bit
No ow control
NOTE: The Micro USB-B console port does not provide console access in the ONIE bootloader or ONIE. To navigate the ONIE
bootloader and access ONIE, use the RS-232/RJ-45 serial console port.
NOTE: Before starting this procedure, be sure that you have a terminal emulation program already installed on your PC. Install
the appropriate drivers to support the Micro USB-B port. For assistance, contact Dell Technical Support.
1 Power on the PC.
2 Connect the USB-A end of cable into an available USB port on the PC.
3 Connect the Micro USB-B end of cable into the Micro USB-B console port on the system.
4 Power on the system.
5 Install the necessary USB device drivers.
You need an internet connection. For assistance, contact Dell Technical Support.
6 To access the S6010–ON, open your terminal software emulation program.
7 Keep the default terminal settings as follows:
115200-baud rate
No parity
Eight data bits
One stop bit
No ow control
USB storage mount
USB storage does not automatically mount. The supported le system is FAT. To use USB storage, you must rst mount the device.
1 Create a mount directory for the USB.
ONIE:/ # mkdir /mnt/usb
2 View the xed disks using fdisk.
ONIE:/mnt # fdisk -l
For internal storage:
Disk /dev/sda: 15.8 GB, 15829303296 bytes
255 heads, 63 sectors/track, 1924 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System
/dev/sda1 1 1925 15458303+ ee EFI GPT
Management ports
37