Install Guide
LED Description
• Solid green—fan is operating normally
• Solid amber—fan failure
PSU LED
• O—no power to PSU/failure
• Solid green—PSU is operating normally
• Blinking green—PSU is turned o
Prerequisite
The following is a list of components you need to install the system:
NOTE: For more information, see Site Preparations and Install the S6010-ON.
• S6010–ON chassis or multiple chassis, if stacking.
• AC or DC country/regional-specic cables to connect the AC or DC power source to each of the chassis’ AC or DC power supplies.
• Dell ReadyRail™ mounting brackets for rack installation.
• Screws for rack installation.
• Grounding kit for chassis—GND lug, L-bracket, and screws
Items that are not included:
• GND lug and screws for rack
• Ground wire
• Crimping tool
• Anti-oxidant compound—Dell recommends NOALOX 4 or equivalent
• Thread-locker compound—Dell recommends Threadlocker Blue 242 or equivalent
• #1 and #2 Phillips screwdrivers
• Torx screwdriver
• Copper/ber cables
Other optional components are:
• Extra fan module—recommended for redundancy
• Extra mounting brackets—if installing in a four-post rack or cabinet
S6010–ON Congurations
You can order the S6010–ON system in several dierent congurations. You can also order optional modules and optics separately.
You can order the following supported hardware components:
• S6010–ON AC or DC Normal Airow: 32 xed 40 Gbps QSFP+ ports, two AC power supply units and ve fan subsystems. Airow is
from the I/O side to the PSU side.
• S6010–ON AC or DC Reverse Airow: 32 xed 40 Gbps QSFP+ ports, two AC power supply units and ve fan subsystems. Airow
from the PSU side to the I/O side.
• Fan with airow from the I/O side to the PSU side
• Fan with airow from the PSU side to the I/O side
• AC or DC power supply with airow from the I/O side to the PSU side
• AC or DC power supply with airow from the PSU side to the I/O side
S6010–ON System
11