Administrator Guide
Version Description
8.3.10.0 Introduced on the S4810.
Usage Information
Because this command calculates based on a Layer 2 hash algorithm, use this command to display flows for
switched Layer 2 packets, not for routed packets (use the show ip flow command to display routed packets).
The show port-channel-flow command returns the egress port identification in a given port-channel if a
valid flow is entered. A mismatched flow error occurs if MAC-based hashing is configured for a Layer 2 interface
and you are trying to display a Layer 3 flow.
The output displays three entries:
• Egress port for unfragmented packets.
• In the event of fragmented packets, the egress port of the first fragment.
• In the event of fragmented packets, the egress port of the subsequent fragments.
NOTE: In the show port channel flow command output, the egress port for an unknown
unicast, multicast, or broadcast traffic is not displayed.
The following example shows the show port-channel-flow outgoing-port-channel number
incoming-interface interface source-mac address destination-mac address
• Load-balance is configured for MAC
• Load-balance is configured for IP 4-tuple/2-tuple
• A non-IP payload is going out of Layer 2 LAG interface that is a member of VLAN with an IP address
Example
DellEMC# show port-channel-flow outgoing-port-channel 1 incoming-interface
te 1/1/3
source-mac 00:00:50:00:00:00 destination-mac 00:00:a0:00:00:00
Egress Port for port-channel 1, for the given flow, is Te 1/2/2
ip http source-interface
Specify an interface as the source interface for HTTP connections.
Syntax
ip http source-interface interface
To delete an interface, use theno ip http source-interface interface command.
Parameters
interface
Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
688 Interfaces