Specifications
Table Of Contents
- Open Networking Hardware Diagnostic Guide April 2016
- About this Guide
- Installation Instructions for ONIE and the Dell OS
- ONIE Overview
- Dell DIAG OS
- Dell DiagOS Tools
- Technical Support
• Installing the DIAG-OS — Install the DIAG-OS from the ONIE prompt. Ensure that your TFTP server is
reachable over your network.
• The ONIE operates using a 115200 baud rate. Ensure that any equipment attached to the serial port can
support the required 115200 baud rate.
NOTE: The following output examples are for reference only; your output may be different.
NOTE: The management port IP, FTP server IP address, MAC address, and user-id shown are for
illustration purpose only. You must use your system’s applicable values.
ONIE Service Discovery and OS
Installation
ONIE attempts to locate the installer through several discovery methods, as shown. To download and run an
installer, the ONIE Service Discovery feature uses the first successful method found.
1 Passed from the boot loader.
2 Search locally attached storage devices for one of the ONIE default installer filenames (for example,
USB).
3 Exact the URLs from DHCPv4.
4 Inexact the URLs based on the DHCPv4 responses.
5 Query to the IPv6 link-local neighbors using HTTP for an installer.
6 TFTP waterfall — from the DHCPv4 option 66
Examples of the ONIE ifconfig eth0 Commands
If none of the ONIE Service Discovery methods are successful, you can disable this using the onie-
discovery-stop command.
You can install an operating system manually from HTTP, FTP, or TFTP using the onie-nos-install <URL>
command.
NOTE: If you have a recovery USB plugged into your system, you must remove it prior to installing the
DIAG-OS using the onie-nos-install <URL> command.
The ONIE Install environment uses DHCP to assign an IP address to the management interface (eth0). If that
fails, it uses the default IP address 192.168.3.10/255.255.255.0.
To display the IP address, use the ifconfig eth0 command, as shown in the following example.
ONIE:/ # ifconfig eth0
eth0 Link encap:Ethernet HWaddr 90:B1:1C:F4:9C:76
inet addr:n.n.n. Bcast:n.n.n.n Mask:n.n.n.n
inet6 addr: fe80::92b1:1cff:fef4:9c76/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:18 errors:0 dropped:0 overruns:0 frame:0
TX packets:24 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000
RX bytes:1152 (1.1 KiB) TX bytes:6864 (6.7 KiB)
Interrupt:21 Memory:ff300000-ff320000
Installation Instructions for ONIE and the Dell OS 10










