Users Guide

Example
Dell(conf-if-te-1/1/1)# ipv6 nd dns-server 1000::1 1
ipv6 route
Establish a static IPv6 route.
Syntax
ipv6 route [vrf vrf-name] ipv6-address prefix-length {ipv6-address
| interface | interface ipv6-address} [distance] [tag value]
[permanent] [weight weight-value]
To remove the IPv6 route, use the no ipv6 route command.
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the
VRF to install IPv6 routes in that VRF.
ipv6-address
prefix-length
Enter the IPv6 address in the x:x:x:x::x format then the prefix
length in the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel
then a number.
• For a Null interface, enter the keyword null then the Null
interface number.
• For a tunnel interface, enter the keyword tunnel then the
tunnel interface number. The range is from 1 to 16383.
• For a VLAN interface, enter the keyword VLAN then the
vlan number. The range is from 1 to 4094.
If you configure a static IPv6 route using an egress interface and
enter the ping command to reach the destination IPv6 address,
the ping operation may not work. Configure the IPv6 route using
IPv6 Basics 928