Users Guide

Usage Information You can use this command to view the number of supported extended prefix entries in
LPM configured. The output also displays the current applied value and the new value
that is applicable after the reboot of the device.
Example
Dell# show cam-ipv6 extended-prefix
Cam-Ipv6-LPM Extended Prefix
--------------------------------
Current Settings
cam-ipv6-max-/65-to-/128-Prefix : 2048
Dell(conf)#
ipv6 unicast-host-route
Enable programming of IPv6 /128 route prefixes in L3 host table.
Syntax
[no] ipv6 unicast-host-route
Defaults Enabled by default. By default, all the IPv6/128 route prefixes are installed only in L3
host table.
Command Modes CONFIGURATION
Command History
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.3(0.1) Introduced on the S6000.
Usage Information You can use this command to enable programming of /128 route prefixes in L3 host
table or in LPM table. A warning message is displayed when you enter this command
stating that this setting takes effect for existing routes only when IPv6 route prefixes are
cleared from the routing table (RTM). To enable programming of /128 route prefixes in
LPM table, use no ipv6 unicast-host-route command.
Example
Dell(conf)# ipv6 unicast-host-route
Warning: Command will take effect for existing routes only when
IPv6
route prefixes are cleared from RTM
Dell(conf)#no ipv6 unicast-host-route
Warning: Command will take effect for existing routes only when
IPv6
IPv6 Basics 926