Users Guide

ipv4 unicast-host-route
Enable programming of IPv4 /32 route prefixes in L3 host table.
Syntax
[no] ipv4 unicast-host-route
Defaults Disabled by default. By default, all the IPv4 route prefixes are installed only in the LPM
table.
Command Modes CONFIGURATION
Command History
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.7(0.0) Introduced on the S6000-ON.
9.3(0.1) Introduced on the S6000.
9.2(1.0) Introduced on the Z9500.
Usage Information A warning message is displayed when you enter this command stating that this setting
takes effect for existing routes only when IPv4 route prefixes are cleared from the
routing table (RTM). To disable this functionality, use no ipv4 unicast-host-route
command.
Example
Dell(conf)#ip unicast-host-route
Warning: Command will take effect for existing routes only when
IPv4
route prefixes are cleared from RTM
Dell(conf)#no ip unicast-host-route
show ip tcp initial-time
Displays the interval that you configured for the device to wait before the TCP connection is attempted to be
established.
Syntax
show ip tcp initial-time
Command Modes
EXEC
IPv4 Routing 883