Users Guide

ip helper-address hop-count disable
Disable the hop-count increment for the DHCP relay agent.
Syntax
ip helper-address hop-count disable
To re-enable the hop-count increment, use the no ip helper-address hop-
count disable command.
Defaults Enabled; the hops field in the DHCP message header is incremented by default.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.3.1.0 Introduced for the E-Series.
Usage Information This command disables the incrementing of the hops field when boot requests are
relayed to a DHCP server through Dell Networking OS. If the incoming boot request
already has a non-zero hops field, the message is relayed with the same value for hops.
IPv4 Routing 868