Users Guide

members have a link MTU of 2100 and an IP MTU 2000, the Port Channel’s MTU
values cannot be higher than 2100 for link MTU or 2000 bytes for IP MTU.
When an interface is removed from a Port Channel with the no channel-member
command, the interface reverts to its configuration prior to joining the Port Channel.
An interface can belong to only one Port Channel.
You can have 16 interfaces per Port Channel. The interfaces can be located on different
line cards but must be the same physical type and speed (for example, all 10-Gigabit
Ethernet interfaces).
For more information about Port Channels, refer to the Dell Networking OS
Configuration Guide.
Related
Commands
• description — assign a descriptive text string to the interface.
• interface port-channel — create a Port Channel interface.
• shutdown — disable/enable the port channel.
group
Group two LAGs in a supergroup (“fate-sharing group” or “failover group”).
Syntax
group group_number port-channel number port-channel number
To remove an existing LAG supergroup, use the no group group_number command.
Parameters
group_number Enter an integer from 1 to 32 that uniquely identifies this LAG
fate-sharing group.
port-channel
number
Enter the keywords port-channel then an existing LAG
number. Enter this keyword/variable combination twice,
identifying the two paired LAGs.
Defaults None
Command Modes PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
Interfaces 827