Users Guide

You can change this default quad port profile configuration using the stack-unit
stack-unit-number quad-port-profile port-numbers command and include
the top four left ports and top four right ports in your new profile. When you change
the default profile, you can dynamically fan-out the ports that are part of the new
profile using the
stack-unit stack-unit-number portmode command.
However, your new profile must exclude four ports from the first 16 port groups and
four ports from the last 16 port groups in the switch. You cannot fan-out these
excluded ports as the quad port profile can only have 12 ports in the first 16 port groups
and 12 ports in the last 16 port groups.
NOTE: In order for the new quad port profile configuration to take effect, you
must first save changes and then reload the switch.
show interfaces switchport
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode
interfaces’ IEEE 802.1Q tag status and VLAN membership.
Syntax
show interfaces switchport [interface-type | stack-unit unit-id ]
Parameters
interface-type (OPTIONAL) Enter one of the following keywords and the
interface information:
• For a port channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a backup interface for this interface, enter the keyword
backup.
NOTE: This command also enables you to view
information corresponding to a range of ports.
• For physical interfaces, you can specify multiple ports as
slot/port-range. For example, if you want to display
information corresponding to all ports between 1 and 4,
specify the port range as show interfaces
interface-type 1/1 - 4.
• For port–channel interfaces, you can specify multiple ports
as port-range. For example, if you want to display
information corresponding to all ports between 1 and 4,
specify the port range as show interfaces port—
channel 1 - 4
.
stack-unit unit-id (OPTIONAL) Enter the keywords stack-unit then the stack
member number.
Interfaces 810