Users Guide

20 20
21 21
22 22
23 23
24 24
25 25
27 27
29 29
31 31
Dell(conf)#stack-unit 1 port 24 portmode quad
Warning: Enabling quad mode on stack-unit 1 port 24. Please
verify whether the configs related to interface Fo 1/24 are
cleaned up before proceeding further.
[confirm yes/no]:yes
Dell(conf)#00:02:24: %STKUNIT1-M:CP %IFMGR-5-DYNAMIC_FANOUT: Port
24 in slot 1 has been fanned-out >>>>>
Dell(conf)#00:02:27: %S6000-ON:1 %IFAGT-5-INSERT_OPTICS_QSFP:
Optics QSFP inserted in slot 1 port 24/2
00:02:27: %S6000-ON:1 %IFAGT-5-INSERT_OPTICS_QSFP: Optics QSFP
inserted in slot 1 port 24/3
i00:02:27: %S6000-ON:1 %IFAGT-5-INSERT_OPTICS_QSFP: Optics QSFP
inserted in slot 1 port 24/4
Related
Commands
stack-unit portmode — splits a single 40G port into four-10G ports
stack-unit quad-port-profile
Configures the list of dynamic fan-out capable ports.
Syntax
stack-unit [stack-unit number] quad-port-profile [default|<1–32>]
To remove the quad-port configuration, use the [no] stack-unit[stack-unit
number] quad-port-profile [default|<1–32>]command syntax.
Parameters
stack-unit
number<1–32>
Enter the port number. The range is from 1 to 6.
The range of the default ports are separated by —,
Defaults 2,4,6,8,9,10,11,12,13,14,15,16,17,18,19,20,21,22,23,24,25,27,29,31
Command Modes CONFIGURATION
Command History
Version Description
9.7(0.0) Introduced on the S6000 and S6000–ON.
Usage Information
The default quad port profile configuration includes all ports except the top four left
ports and the top four right ports in the switch. As a result, you cannot fan-out these
switch ports using the stack-unit stack-unit-number portmode command
when the ports are in the default quad port profile configuration.
Interfaces 809