Users Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.2) Added support for the tunnel interface type.
9.1(0.0) Updated Management Ethernet output to include two global
IPv6 addresses on S4810 and Z9000 and added output example
showing OpenFlow instance ID.
8.3.12.1 Updated command output to support multiple IPv6 addresses
on S4810.
8.3.11.4 Output expanded to support eSR4 optics in Z9000.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.2.1.2 Included SFP and SFP+ optics power detail in the E-Series and
C-Series output.
8.2.1.0 Added support for 4093 VLANs on the E-Series. Prior releases
supported 2094.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Output expanded to include SFP+ media on the C-Series.
7.6.1.0 Introduced on the S Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Changed the organization of the display output.
6.3.1.0 Added the Pluggable Media Type field in the E-Series output.
Usage Information
Use the show interfaces command for details on a specific interface.
NOTE: In the CLI output, the power value is rounded to a 3-digit value. For
receive/transmit power that is less than 0.000, an snmp query returns the
corresponding dbm value even though the CLI displays as 0.000.
NOTE: After the counters are cleared, the line-rate continues to increase until it
reaches the maximum line rate. When the maximum line rate is reached, there is
no change in the line-rate.
User Information
The following table describes the show interfaces command shown in the 10G
example.
Line Description
TenGigabitEthern
et 1/1...
Interface type and administrative and line protocol status.
Interfaces 794