Users Guide

Usage Information
Only VLAN and port-channel interfaces created using the interface vlan and
interface port-channel commands can be used in the interface range
command.
Use the show running-config command to display the VLAN and port-channel
interfaces. VLAN or port-channel interfaces that are not displayed in the
show
running-config
command cannot be used with the bulk configuration feature of the
interface range command. You cannot create virtual interfaces (VLAN, Port-
channel) using the
interface range command.
NOTE: If a range has VLAN, physical and port-channel interfaces, only
commands related to physical interfaces can be bulk configured. To configure
commands specific to VLAN and port-channel only those respective interfaces
should be configured in a particular range.
Example (Single
Range)
This example shows a single range bulk configuration.
Dell(config)# interface range tengigabitethernet 1/1/1 - 1/7/3
Dell(config-if-range-te-1/1/1-1/7/3)# no shutdown
Example (Multiple
Range)
This example shows how to use commas to add different interface types to a range of
interfaces.
Dell(config-if)# interface range tengigabitethernet 1/1/1 -
1/20/3, hundredGigE 1/24 - 1/29
Dell(config-if-range-te-1/1/1-1/20/3,hu-1/24-1/29)# no shutdown
Example (Multiple
Range)
This example shows how to use commas to add VLAN and port-channel interfaces to
the range.
Dell(config-if)# interface range tengigabitethernet 1/1/1 -
1/20/3, tengigabitethernet 1/23/1 –1/24/4,
Vlan 2–100, Port 1–25
Dell(config-if-range-
te-1/1/1-1/20/3,te-1/23/1-1/24/4,vl-2-100,po-1-25)# no shutdown
Dell(config-if-range)#
Related
Commands
• interface port-channel — configure a port channel group.
• interface vlan — configure a VLAN interface.
• show config (from INTERFACE RANGE mode) — display the bulk configuration
interfaces.
• show range — display the bulk configuration ranges.
• interface range macro (define) — define a macro for an interface-range.
Interfaces 773