Users Guide

• For a port channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
Defaults Not configured.
Command Modes INTERFACE VLAN — (conf-if-vl-n)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command.
Usage Information The Dell Networking OS provides the capability of statically configuring the interface to
which a multicast router is attached. To configure a static connection to the multicast
router, enter the ip igmp snooping mrouter interface command in the VLAN
context. The interface to the router must be a part of the VLAN where you are entering
the command.
Internet Group Management Protocol (IGMP) 747