Users Guide

Version Description
7.8.1.0 Introduced on the C-Series and S-Series.
7.7.1.0 Introduced on the E-Series.
Usage Information Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected in
the IGMP groups. You may not use extended access lists with this command. When you
configure a static SSM map and the router cannot find any matching access lists, the
router continues to accept (*,G) groups.
Related
Commands
• ip access-list standard — create a standard access list to filter based on IP address.
ip igmp version
Manually set the version of the router to IGMPv2 or IGMPv3.
Syntax
ip igmp version {2 | 3}
Parameters
2 Enter the number 2 to set the IGMP version number to IGMPv2.
3 Enter the number 3 to set the IGMP version number to IGMPv3.
Defaults 2 (IGMPv2)
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Changed the default IGMP from version 2 to version 3.
Introduced on the S6000-ON
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Internet Group Management Protocol (IGMP) 733