Users Guide

ip igmp ssm-map
To translate (*,G) memberships to (S,G) memberships, use a statically configured list.
Syntax
ip igmp [vrf vrf-name] ssm-map std-access-list source-address
Undo this configuration, that is, remove SSM map (S,G) states and replace them with
(*,G) state, use the ip igmp [vrf vrf-name] ssm-map std-access-list
source-address command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the
VRF to configure this setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
std-access-list Specify the standard IP access list that contains the mapping
rules for multicast groups.
source-address Specify the multicast source address to which the groups are
mapped.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF and Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Internet Group Management Protocol (IGMP) 732