Users Guide

NOTE: Designate the milliseconds in multiples of 100.
leave Enter the keyword leave then the number of milliseconds to
configure the leave time. The range is from 100 to 2147483647
milliseconds. The default is 600 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
leave-all Enter the keywords leave-all then the number of
milliseconds to configure the leave-all time. The range is from
100 to 2147483647 milliseconds. The default is 1000
milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
Defaults As above.
Command Modes CONFIGURATION-GVRP
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on C-Series, E-Series, and S-Series
Usage Information
• Join Timer — Join messages announce the willingness to register some
attributes with other participants. For reliability, each GARP application entity
sends a Join message twice and uses a join timer to set the sending interval.
• Leave Timer — Leave announces the willingness to de-register with other
participants. Together with Join, Leave messages help GARP participants
complete attribute reregistration and de-registration. The leave timer starts after
receipt of a leave message sent for de-registering some attribute information. If a
GARP VLAN Registration (GVRP) 711