Users Guide

scheduling, and that share latency and loss requirements. All 802.1p priorities mapped
to the same queue must be in the same priority group.
Repeat the priority-group bandwidth pfc command to configure PFC and ETS
traffic handling for each priority group in a DCB map.
You can enable PFC on a maximum of two priority queues.
If you configure more than one priority group as strict priority, the higher numbered
priority queue is given preference when scheduling data traffic.
If a priority group does not use its allocated bandwidth, the unused bandwidth is made
available to other priority groups.
To remove a priority-group configuration in a DCB map, enter the no priority-
group bandwidth pfc
command.
By default, equal bandwidth is assigned to each dot1p priority in a priority group. Use
the bandwidth parameter to configure the bandwidth percentage assigned to a
priority group. The sum of the bandwidth allocated to all priority groups in a DCB map
must be 100% of the bandwidth on the link. You must allocate at least 1% of the total
port bandwidth to each priority group.
dcb-map stack-unit all stack-ports all
Apply the specified DCB map on all ports of the switch stack.
Syntax
dcb-map stack-unit all stack-ports all dcb-map-name
To remove the PFC and ETS settings in a DCB map from all stack units, use the no
dcb-map stack-unit all stack-ports all command.
Parameters
dcb-map-name Enter the name of the DCB map.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.7(0.0) Introduced on the S6000-ON.
9.3(0.0) Introduced on the S4810 and S6000 platforms.
Data Center Bridging (DCB) 563